NOTE: By default the LAN IP address is 192.168.0.1. Most of Technicolor Gateways run customized firmware implementing ISP-specific integrations and get locked down in functionality to match service requirements. We will need to do two things before we proceed with configuring the Technicolor into bridge mode: Install the snmpset program (Provided by the snmp package for Debian/Ubuntu) Connect via LAN cable to the Technicolor. Enter into the address box, and press the Enter key. Launch a web browser, such as Internet Explorer, Firefox, or Safari.Hosting services or applications that can benefit from being directly accessible from the Internet.The WNDR3700V3 is in AP mode right now, I cannot get internet access. I chose to enable bridge mode on my Xfinity router (Technicolor DPC3941T), not sure what to configure on my WNDR3700v3 (using dd-wrt) for the bridge mode to work correctly. Adding a firewall, router or another NAT device to manage the Local Area Network Im bridging myXfinity modem with my NetGear WNDR3700v3 router.NOTE 2: The Bridge Mode feature is not included with units that have been leased or purchased from Shaw communications. Those who are using a Homeware gateway in bridge modes would normally have all.
NOTE 1: Although the TG862 does not route traffic when Bridge Mode is enabled, it can still act as a firewall if the firewall settings in the TG862 are enabled. You have a complex network setup with a more advanced router running. Thankfully, standard OpenWRT config applies. This document describes how to enable and disable Bridge Mode. Using bridge mode with a dedicated PPPoE ethernet port I use the AP on the device on my LAN, but I also use the modem purely in bridge mode, which means I want to dedicate a port to my router to allow it to do PPPoE to my ISP. For those that haven't figured it out, they have set the modem up to pass the public/static IPs through to the LAN side, so if you have a device that answers to your static IPs on the LAN side, the comcast modem will pass the traffic to it (out of the box, as. You may have to set the TP link to a static IP address in the address range of the Technicolour router. multiple (5) static IPs, QoS router behind Cisco modem and NOT in bridge mode. I am sure that you need to use the TP Link in client mode.
When Bridge Mode is enabled, the router function is turned off and the device directly connected to the TG862 will receive the Public IP address from the Cable Provider. I doubt you want to turn off DHCP in the Technicolour router or use bridge mode - it would cease act as an Access point for all the other WiFi clients. This can be accomplished by configuring the TG862 for Bridge Mode. In certain situations, it may be desired to disable the router function of the TG862, and have it operate as a modem only. When operating as a gateway, the TG862 serves as a modem and a router and keeps the devices in the Local Area Network (LAN) hidden. By default, the TG862 operates as a gateway, and provides Internet access for multiple devices connecting to the TG862 gateway.